Re: ESXi 4.0 Server Crashed
a.p. wrote: You mentioned a 500GB drive in your initial post, but the output shows a 300GB drive!? Can you confirm it's the 300GB drive which should contain the VMFS datastore?Did you setup the host...
View ArticleRe: How to recover VMFS volume after a RAID controller failure
The reason I asked was to understand whether the original partition type was MBR or GPT and the start sector was 128 or 2048.With the information you provided, take a look at Recovering a lost...
View ArticleRe: vCenter Inventory Services
Ok let me try to explain:there are two passwords associated with the admin@system-domain.1) Master password: This is the password that you set while you first install SSO. This cannot be changed...
View ArticleAfter upgrading to 1.5 i cant login to administrate users etc
I can login to the Connector where i where all seems fine. Clicking on "Login in to Horizon" i get to fill in username and then password. It says signing in for 2 seconds and then nothing.. just an...
View ArticleRe: unable to obtain hardware information for the selected machine
Do you use local administrator account? Second: turn off UAC or run Converter client 'as administrator'. HTH
View ArticleRe: Horizon 1.5 change FQDN
I managed to both change certificates and external load balancer + FQDN. In my test i managed to do it in 2 ways. #1: Using the tip in this thread i used the fqdn i wanted as gateway-va name, then i...
View ArticleRe: Linux guest で動作している SAMBAへ Windows host から接続出来ません。
ご回答ありがとうございました。事情により，すぐには試すことができませんが，試行ができたらその後の状況をご報告します。
View ArticleRe: unable to obtain hardware information for the selected machine
Issues like this are often seen with UAC enabled and/or with running the Converter without the required permissions. Please try to start the Converter by right clicking and "Run as Administrator". If...
View ArticleRe: HOL Stucked at - starting lab
It looks like there might have been an issue earlier but at this point, I was able to start a lab. Thanks for your patience and please try again. Bill
View ArticleClik here to view.
Re: Vsphere 4 or Vsphere 5
Here is Vmware Vsphere hyper/trial version ...http://www.vmware.com/support/product-support/vsphere-hypervisor.htmlRegards,Milton
View ArticleClik here to view.
Expanding data disk in vmware esx server 3
Hi, I havebeen askedby a colleagueif I canbe of assistanceto expandd: \ driveon an existingvirtualwindows2003 server. They use:VMwareESXServer3iVersion3.5.0Build110271VMwareInfrastructure...
View ArticleClik here to view.
Re: Seperating VMs in vApp by their OS
Hello Bruke, Thanks for the code. I think it is really close. I've made necessary changes to the input and output parameters and tried running the workflow. Below is what I got... [2013-08-14...
View ArticleClik here to view.
Re: Update manger IP address issue
Ill give that a try. Thanks! It seems odd however to think that all vmware would only support having the vcenter(s) server exposed to NICs on hypervisors, ie they think all DC's are built the same way...
View ArticleClik here to view.
Re: Virtual Network with VMware 8 Workstation (Redes privadas virtuales con...
Only things you have to do is... I have got it from vmware kb.To use a network adapter with only the guest virtual machine and to isolate the host, disassociate the network adapter from all protocols...
View ArticleClik here to view.
Re: Getting two VMs to communicate
Hi, when you have NAT configured, both VMs will get an DHCP IP from your PC, not your router. They will communicate with your VMnet8 LAN adapter, that was installed by VMware workstation. Both VMs will...
View ArticleClik here to view.
Re: Cannot connect to guest server
Here is linkk.......http://askubuntu.com/questions/52147/how-can-i-access-apache-on-virtualbox-guest-from-hostRegards,Milton
View ArticleClik here to view.
Re: Update manger IP address issue
Well, I think for most users it's normal that the vCenter runs in the same location as the ESXi hosts And I would not connect remote ESXi hosts without a VPN. So problem solved ( for me :-) ) Also:...
View ArticleRe: My options for fault tolerance, nic teaming, and link aggregation
Idelossa, Correct. NIC teaming in the vSphere hypervisor does not equal LACP or Etherchannel. By default, the balancing algorithm will balance outgoing traffic from the host based on the policy:...
View ArticleRe: Expanding data disk in vmware esx server 3
Yes this should even work with the VM powered on. After expanding the virtual disk in the GUI, connect to the Windows 2003 VM (either open the console or via an administrative RDP session) and rescan...
View Article